The ESH-A Remote Sensor offers flexible location monitoring of combustible gases or PID TVOCs in non-hazardous, non-explosion rated, commercial and light industrial applications. It communicates with the device it is attached to using current loop into a 100 ohm load or a voltage signal of 0.40 to 2 volts. It can be located at a maximum distance of 200 meters from the compatible controller or transmitter.
The mounting height of the ESH-A Remote Sensor depends on the gas being monitored. A gas that is heavier than air should be detected 6 inches from the floor and a gas that is lighter should be detected on or near the ceiling. A gas that has the same density as air should be detected in the “breathing zone”, where most human breathing takes place, which is 1 to 2 m (4 to 6 ft) from the floor.
The ESH-A Remote Sensor comes in a standard water / dust tight, corrosion resistant ABS / polycarbonate enclosure with a hinged, secure door and is designed to protect the sensor and provide easy mounting components.
An optional splash guard may be installed to further protect the remote sensor in water spray or washdown applications.
The ESH-A Remote Sensor is not a standalone device, it must be used with the SCC, DCC, LPT-A, LPT-P, LPT-M, LPT-B, CGAS-A or CGAS-D (remote sensor's target gas will differ based on device).
Call DOD Technologies today to learn more about this monitor!
- Acetylene (C2H2)
- Hydrogen (H2)
- Methane (CH4)
- Propane (C3H8)
|Product Type||Commercial Gas Detectors|
|Dimensions||5 x 5 x 2.1"|
|Detection Range||Variable by Gas|
|Event Log Storage||Yes|
|Alarms||Audible & Visual|
|Operation Temperature||32°F to +104°F (0°C to 40°C)|